microchip-application-pec930-pec930_peripheral/Examples/uart/uart_Interrupt/readme.md

uart_Interrput

This is an example of UART Interrput

• Select the UART TX/RX pins

  // in main.c
  #define CONFIG_UART_IO_TX_PORT		GPIOA
  #define CONFIG_UART_IO_TX_PIN		GPIO_Pin_01
  #define CONFIG_UART_IO_TX_AF_MODE	GPIO_AF_1
  #define CONFIG_UART_IO_RX_PORT		GPIOA
  #define CONFIG_UART_IO_RX_PIN		GPIO_Pin_00
  #define CONFIG_UART_IO_RX_AF_MODE	GPIO_AF_1
  

• Configure the parameters related to UART

  // in main.c
  #define CONFIG_BAUD_RATE_VALUE  38400
  UART_WordLength_8b	//Data bit 8
  UART_StopBits_1		//Stop bit 1
  UART_Parity_No		//No check bit
  UART_Mode_TxRx	//Transmit-Receive Mode
  

• Select the UART interrupt mode

• It can be modified according to the requirements

  // in main.c
  UART_ITConfig(UART0, UART_IE_RXNEE_Msk, ENABLE);
  

Log

Use serial port with baudrate 38400, 8bit, no parity check

• SET different uart flag bits to enable interrupts
• Send the corresponding success log in the interrupt function